Table of Contents
Advertisement
Installation • Installation
3. Install the retaining clips on the device. To do this, insert the clips into the openings on the sides of the device
(indicated by orange circles). The number of retaining clips may vary depending on the display unit. The exact
number can be found in Figure 7 "Panel PC 900 + power supply + bus units - Installation diagram" on page 22.
4. Now fasten the retaining clips to the wall or control cabinet by alternately tightening the screws with a hex-
head screwdriver. The tightening torque should be max. 1 Nm to provide an optimal seal.
Wall or
Control cabinet plate
1.2 Installation information for individual components
Information:
If the Panel PC 900 is not delivered as a complete system but as individual components (or individual
components are installed afterward), then these components must be enabled in BIOS. To do this, open
BIOS when booting the system, load the default BIOS values and then save the settings. For additional
information, see "Save & Exit" on page 223. This is required for the following individual components:
• CPU board and system unit
• Interface option
• Fan kit
• Bus unit
134
Figure 54: Inserting the retaining clips
1 - 6 mm
Figure 55: Fasten retaining clips
Panel PC 900 User's Manual V1.05
Advertisement
Table of Contents
