Table of Contents
Advertisement
1.9 Replacing the fan filter
1. Disconnect the power supply to the B&R industrial PC (unplug the power cable!). Isolate from all potential
sources of electrical power!
2. Touch the housing or ground connection in order to discharge any electrostatic charge from your body.
3. Press down the indicated latching mechanism ➀ while pulling out the filter cover ➁ at the same time.
4. Insert the new filter cover into the fan kit by following these instructions in the reverse order.
Panel PC 900 User's Manual V1.05
Figure 78: Removing the filter cover
Installation • Installation
Filter cover
147
Advertisement
Table of Contents
