Driver’s Seat Belt Reminder/Warning Light And Display - Mitsubishi LANCER 2012 Manual

Seat and restraint systems
Driver's seat belt reminder/warning light and
display
Warning light
Warning display type 1
2
Warning display type 2
A tone and warning light are used to remind the driver to fasten
the seat belt.
If the ignition switch is set to the "ON" position without the
driver's seat belt being fastened, a warning light will come on
and a tone will sound for approximately 6 seconds to remind
you to fasten your seat belt.
If you then drive with the seat belt unfastened for longer than a
minute from when the ignition switch was turned on, the warn-
ing light will come on and blink repeatedly and the tone will
sound intermittently.
The warning light and the tone will stop after approximately 90
seconds.
2-18
If you then repeatedly stop and start your vehicle with the seat
belt unfastened, the warning light/display and tone will remind
you to fasten your seat belt every time the vehicle starts mov-
N00418400300
ing. You will also be reminded to fasten your seat belt in this
way when you remove your seat belt while driving. The warn-
ing light and the tone go off when the seat belt is fastened.
WARNING
!
In order to reduce the risk of serious injury or death
in an accident, always wear your own seat belt. Do
not allow anyone to ride in your vehicle unless he or
she is also seated and wearing a seat belt. Children
should additionally be restrained in a secure child
restraint system.
NOTE
At the same time, "FASTEN SEAT BELT" will be dis-
played on the information screen in the multi-information
display.
I n f o r ma t i o n P r o v i d e d b y :