Installing / Removing The Base Stand - Logik L22FED13 Instruction Manual

Installing / Removing the Base Stand

The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be
sure that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it.
DO NOT exert pressure on the front of the TV at any time because the screen could crack.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up. Please make sure a soft cushioned material (such as a pillow or
thick piece of foam) is placed beneath the screen.
3. To install the TV stand, first attach the stand support
to the TV by using screw A. Align the screw hole then
use screw A to fix the stand support to the TV.
GB
4. To install the base stand,
align the screw holes, then
secure with a screw driver (not
included) using the 3 screw B
provided.
Remove the stand assembly before mounting the TV onto the wall.
5. To remove the stand assembly, untighten the screw
holding the stand assembly to the rear of the TV. Slide
the stand assembly out.
Keep all the spare screws should you want
to use the stand assembly option.
6. Mounting on the wall. This TV is designed to be
wall-mounted with a standard 100 mm x 100 mm
mounting kit (sold separately) designed for flat-panel
TVs. Mount this TV according to the instructions
included in the mounting kit. Due to space restrictions,
we recommend that you make all connections (refer to
page 15-18 and page 45 for details) before mounting
on to the wall.
Use the supplied 4 rear spacers to mount TV's with curved/
recessed backs, recessed mounting holes, or to allow access to
A/V inputs.
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance please call our UK Call Centre on 0844 561 1234. Our UK
Customer Contact Centre is open Monday-Saturday 8am-8pm or Sunday 8am-6pm.
8
L22_24FED13_IB_RC131024_Annie.indd 8
TV Front
Base Stand
Front
Screw B x 3
Four mounting holes
(size M4x5 screw)
Screw A x 1
screw
unscrew
Screw A x 1
100 mm
screw
rear spacer
24/10/13 5:38 PM