Installing / Removing The Base Stand - Logik L40DIGB20 Instruction Manual

Installing./.Removing.the.Base.Stand
Remove the base stand before mounting the TV onto the wall.
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure
that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO
NOT exert pressure on the front of the TV at any time because the screen could crack.
1.. Disconnect all cables connected to the TV.
2.. Lay the TV down on a flat surface with the back side
facing up. Please make sure to place a soft cushioned
material (such as a pillow or thick piece of foam)
beneath the screen.
3.. To install the base stand, attach the base stand with
the supplied screws.
4.. To remove the base stand, the 6 screws that hold the
base stand to the rear of the TV.
Keep all the spare screws should you want to use
the base stand option.
5.. Mounting on the wall. This TV is designed to be wall-
mounted with a standard 400 mm x 200 mm mounting
kit designed for flat-panel TVs (sold separately).
Mount this TV according to the instructions included
in the mounting kit. Due to the space restriction, we
recommend that you make all connections before
mounting on the wall (refer to page 12-16 for details).
6.. To re-install the base stand reattach the base stand
with the 6 screws
If items are missing, or damaged please contact Partmaster
(UK only). Tel: 0844 800 3456 for assistance.
Please read this instruction manual carefully while setting up your TV.
If you require additional assistance please call our Customer Technical Services Centre.
Tel: 0844.800.6020 (UK only)
GB-6
Screws A x 6
(P.N..I.03.TW4016A01)
Screws B x 4
(P.N..I.03.MW4012001)
Screws A x 2
(P.N..I.03.TW4016A01)
400.mm
Four mounting holes
(size M5 screw)
Screw