Installing / Removing The Base Stand - Logik L40LCD11 Instruction Manual

Installing / Removing the Base Stand

• Remove the base stand before mounting the TV onto the wall.
• The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be
sure that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with
it. DO NOT exert pressure on the front of the TV at any time because the screen could crack.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side
facing up. Please make sure to place a soft cushioned
material (such as a pillow or thick piece of foam) beneath
the screen.
GB
3. To install the base stand first make sure you position the
front of the base stand at the front of the TV. Align the 2
plugs with the 2 locator holes. There is only one way for
the base stand to connect to the TV.
The screw holes will only align if the front
of the base stand is at the front of the TV.
4. The 6 screw holes should now be aligned screw in the 6
screws to fix the base stand to the TV.
5. To remove the base stand, lay the TV down on a flat
surface with the back side facing up. Please make sure
to place a soft cushioned material (such as a pillow or
thick piece of foam) beneath the screen. Untighten the 6
screws that hold the base stand to the rear of the TV. Slide
the base stand out.
Keep all the spare screws should you want
to use the base stand option.
6. Mounting on the wall. This TV is designed to be wall-
mounted with a standard 400 mm x 200 mm mounting
kit designed for flat-panel TVs (sold separately). Mount
this TV according to the instructions included in the
mounting kit. Due to space restrictions, we recommend
that you make all connections (refer to page 13-17 for
details) before mounting on to the wall.
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance please call our UK Call Centre on 0844 561 1234. Our UK
Customer Contact Centre is open Monday-Saturday 8am-8pm or Sunday 8am-6pm.
6
plugs
locator
holes
screw
Screw A x 6
(P.N.: I.03.TW4016A01)
Screw B x 4
(P.N.: I.03.MW4012001)
unscrew
Screw A x 2
(P.N.: I.03.TW4016A01)
400 mm
Four mounting holes
(size M5 screw)
Screws x 3
(P.N.: xxxxxxxxxxx)