Table of Contents
Advertisement
Installing / Removing the Base Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be
sure that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it.
DO NOT exert pressure on the front of the TV at any time because the screen could crack.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV
slightly overhangs on it. Please make sure a soft cushioned material (such as a pillow or thick piece of foam) is placed beneath
the screen.
Installing the Base Stand
1. To install the TV stand, first attach the stand support
to the TV by using screw A. Align with the screw hole
then use screws to fix the stand support to the TV.
2. To install the base stand,
align the screw holes, then
secure with a screw driver (not
included) using the screw B
provided.
The screw holes will
only align if the front of
the base stand is at the
front of the TV.
Mounting the TV to a Wall
Remove the stand assembly before mounting the TV onto the wall.
1. To remove the stand assembly, untighten the screws
holding the stand assembly to the rear of the TV. Slide
the stand assembly out.
Keep all the spare screws should you want
to use the stand assembly option.
2. Mounting on the wall. This TV is designed to be
wall-mounted with a standard 100 mm x 100 mm
mounting kit (sold separately) designed for flat-panel
TVs. Mount this TV according to the instructions
included in the mounting kit. Due to space restrictions,
we recommend that you make all connections (refer to
page 15-18 and page 44 for details) before mounting
on to the wall.
Please read this instruction manual carefully while setting up your TV.
TV Front
Base Stand
Front
Screw B x 1
Four mounting holes
screw in
unscrew
Screw B x 1
100 mm
(size M4x5 screw)
screw in
Screw A x 1
GB
9
Advertisement
Table of Contents
