Table of Contents
Advertisement
Installing / Removing the Base Stand
• Remove the base stand before mounting the TV onto the wall.
• The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be
sure that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with
it. DO NOT exert pressure on the front of the TV at any time because the screen could crack.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side
facing up. Please make sure to place a soft cushioned
material (such as a pillow or thick piece of foam)
beneath the screen.
3. To remove the base stand, untighten the 7 screws that
hold the base stand to the rear of the TV.
4. Attach the cover board by using the 2 screws
(P.N.: GB6560M4X14B-RS/RH) from the base stand.
Keep all the spare screws should you want
to use the base stand option.
5. Mounting on the wall. This TV is designed to be
wall-mounted with a standard 400 mm x 200
mm mounting kit designed for flat-panel TVs
(sold separately). Mount this TV according to the
instructions included in the mounting kit. Due to the
space restriction, we recommend you to make all
connections (refer to page 13-17 for details) before
final mounting on the wall.
6. To re-install the base stand, untighten the 2 screws
that hold the cover board. Take off the cover board
and reattach the base stand with the 5 screws.
If items are missing, or damaged please contact Partmaster (UK only). Tel: 0844 800 3456 for assistance.
Screws x 7
(P.N.: GB6560M4X14B-RS/RH)
400 mm
Four mounting holes
(size M5 screw)
Screws x 7
(P.N.: GB6560M4X14B-RS/RH)
GB
7
Advertisement
Table of Contents
