Installing / Removing The Base Stand - Logik L19LDIB10 Instruction Manual

Installing / Removing the Base Stand

The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure
that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO
NOT exert pressure on the front of the TV at any time because the screen could crack.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side
facing up. Please make sure to place a soft cushioned
material (such as a pillow or thick piece of foam)
beneath the screen.
3.
To install the base stand, make sure the base stand
is correctly orientated as shown in the label at the
bottom of the base stand.
4. Push the base stand into the bottom of the TV until it
locks in place.
Remove the base stand before mounting the TV
onto the wall.
5. To remove the base stand, use your finger to carefully
push up on the latch and pull the base stand out.
6. Mounting on the wall. This TV is designed to be wall-
mounted with a standard 75 mm x 75 mm mounting
kit designed for flat-panel TVs (sold separately).
Mount this TV according to the instructions included
in the mounting kit. Due to the space restriction, we
recommend you to make all connection (refer to page
32 for details) before final mounting on the wall.
Bottom of base stand
FRONT
Front of the TV
Bottom of base stand
FRONT
75 mm
Four mounting holes
(size M4 screw)
Arrow pointing towards
the front of the TV.
FRONT
Latch
GB-5