Installing / Removing The Base Stand - Logik L22DVDB10E Instruction Manual

Installing / Removing the Base Stand

Remove the base stand before mounting the TV onto the wall.
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be
sure that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with
it. DO NOT exert pressure on the front of the TV at any time because the screen could crack.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side
facing up. Please make sure to place a soft cushioned
material (such as a pillow or thick piece of foam)
beneath the screen.
3. To install the base stand, attach the base stand with
the supplied 4 screws.
4. To remove the base stand with stand support,
untighten the 4 screws that hold the base stand to
the rear of the TV.
Keep all the spare screws should you want
to use the base stand option.
5. This TV is designed to be wall-mounted with a
standard 100 mm x 100 mm mounting kit designed
for flat-panel TVs (sold separately). Mount this TV
according to the instructions included in the mounting
kit. Due to the space restriction, we recommend you to
make all connections (refer to page 14-18 for details)
before final mounting on the wall.
ScrewA x 4
(P.N. I.03.TW3010A01)
Unscrew
Screw B x 4
(P.N. I.03.MP4010001)
100 mm
Four mounting holes
(size M4 screw)
GB
7