Basic Unit Operation And Setup; Powering The Unit On And Off - Galileo ADP 4100 Installation And Operator's Manual

Basic Unit Operation and Setup

Powering the Unit On and Off

ADP 4100 Printer Installation and Operators Manual, April 2007
The following elements are part of this menu:
Left Margin shifts the entire printed image left and right (staple
stub direction).
Top Margin shifts the entire printed image to the top and bottom
edges.
Contrast sets print darkness (individual settings for each bin).
Contrast Front Feed is the setting for the reval slot input.
Print speed selects the ticket stock speed through the print head
path area.
Burst position adjustment (individual settings for each bin).
This Unit has been configured at the factory to meet each customer's
requirements. Use the following procedures to power on the Unit and
load ticket stock. If any difficulties are experienced with any of these
procedures, please refer to the "Troubleshooting" section for help.
CAUTION!
To prevent damage, immediately toggle the power switch to the O
(OFF) position if the Unit does not indicate RAM TEST status on the
display within 2-3 seconds after power is applied.
If the display does not show ONLINE status within 30 seconds, refer
to the "Troubleshooting" section for help.
To power-up the Unit, locate the power switch below the front
control panel on the front of the Unit and toggle it to the I (ON)
position. As soon as the Unit is powered on, it will begin
performing an internal self-test procedure that may take up to 10
seconds.
To power-down the Unit, simply toggle the power switch to the O
(OFF) position.
ADP 4100 Printer
17