Table of Contents
Advertisement
ADP 4100 Printer
Cleaning
Using the Cleaning Card
24
This section defines basic cleaning procedures for the Unit. Although
the Unit will perform dependably right out of the box, periodic
inspection and cleaning should be performed to keep it in good
working order.
To prevent damage, Unimark recommends that qualified service
technicians perform these tasks.
The following inspection/cleaning procedures are presented
separately for clarity, but may be performed at the same time:
Note: The Unit contains electronic circuitry, solenoids, and motor-
driven mechanisms that all generate a small amount of heat. In
normal operation, the enclosure may feel warm, particularly on the top
surface, however it should not feel or smell hot.
WARNING
To prevent personal injury, remove power before performing
preventive maintenance.
CAUTION
To prevent damage, do not touch the print head or encoder
components unless standard electrostatic discharge (ESD) handling
precautions are taken.
The Cleaning Card is saturated in a 99% Isopropyl Alcohol cleaning
solution, and has been designed to be fed through the transport
mechanism and clean the print head, print head platen, and encoder
drive wheels. Cleanings cards are available from Unimark by calling
customer service at (800) 451-2926. The part number for the
cleaning card is 700-5014-600 (single), or the card may be ordered as
a kit of five (-605K), twenty-five (-625K), etc.
Do not remove the card from the sealed pouch until you are ready to
insert the card into the Unit.
ADP 4100 Printer Installation and Operators Manual, April 2007
Advertisement
Table of Contents
