Galileo ADP 4100 Installation And Operator's Manual page 30

ADP 4100 Printer
28
1. Toggle the power switch to O (OFF) and disconnect the power
cord from the rear of the Unit.
CAUTION
Take caution when opening the left side door. Refer to
"Installation" section for details on how the left and right side doors
open and the space required.
2. Unlock the door on the left side of the Unit and swing it open.
3. Back the ticket card stock all the way out of the transport
mechanism.
4. Dampen a lint-free cloth with a 99% Isopropyl Alcohol cleaning
solution.
5. Hold the cloth firmly against one of the bottom drive rollers with
one hand while turning the knurled knob clockwise with the other.
Turn the knob a few times and remove the cloth. The cloth will be
discolored from the dust/ink buildup on the roller.
6. Dampen another area of the cloth and repeat this process until the
cloth no longer discolors. This will indicate the roller is clean.
Repeat until all bottom drive rollers are cleaned.
7. Dampen another area of the cloth. Hold the cloth against one of
the top idler rollers with one hand while turning the knurled knob
clockwise with the other. Turn the knob a few times and remove
the cloth. The cloth will be discolored from the dust/ink buildup on
the roller.
8. Dampen another area of the cloth and repeat this process until the
cloth no longer discolors. This will indicate the roller is clean.
Repeat until all top idler rollers are cleaned.
9. After all cleaning is complete, plug the power cord back into the
rear of the Unit, toggle the power switch to I (ON), and reload the
ticket stock. Refer to the "Basic Unit Operation and Setup"
section.
ADP 4100 Printer Installation and Operators Manual, April 2007