Cleaning The Encoder Drive And Idler Rollers - Galileo ADP 4100 Installation And Operator's Manual

Cleaning the Encoder Drive and Idler Rollers

ADP 4100 Printer Installation and Operators Manual, April 2007
"Installation" section for details on how the left door opens and the
space required.
2. Unlock the door on the left side of the Unit and swing it open.
3. Back the ticket stock all the way out of the transport mechanism
by turning the knurled knobs shown in the figure above.
4. Remove ticket stock as necessary and vacuum dust from inside of
Unit.
5. Using compressed air, blow the dust from ticket stock path
grooves in transport mechanism.
6. Using compressed air, blow the dust off the sensors in the ticket
stock path. Refer to the diagram on the left side door (internal
panel) or the sensor location figures in the "Clearing Stock Jams"
section.
7. After all cleaning is complete, plug the power cord back into the
rear of the Unit, toggle the power switch to I (ON), and reload the
ticket stock. Refer to the "Basic Unit Operation and Setup"
section.
Use the following steps to manually clean the encoder drive rollers:
ADP 4100 Printer
27