Attaching The Ticket Catcher; Location And Setup - Galileo ADP 4100 Installation And Operator's Manual

ADP 4100 Printer

Attaching the Ticket Catcher

Location and Setup

10
Remove the ticket catcher from the Accessories Kit. Hold the catcher
by the sides, between your thumb and fingers, with the open end of
the catcher facing up. Set the bottom of the catcher into the bottom of
the opening in the front of the Unit. Gently squeeze the sides of the
ticket catcher and push it into place. Let go of the ticket catcher and it
will remain in place.
Handle
The Unit can incorporate a handle located on the front just below the
user interface keypad. The handle is designed to assist the operator
when rolling the Unit out to load stock and for service and product
support. The handle is not to be used to lift Unit, which could result in
product damage.
Bin C Shelf
The Unit can incorporate a shelf to support stock for the Bin C input.
The shelf is located on the rear of the Unit. During shipment it is
stored in the locked upright location. During on-site installation, the
shelf can be pulled down from the top and let down to the horizontal
(down) location. A support chain will limit the downward swing of the
shelf.
Choose a location that provides at least 1-inch of open space
between surfaces adjacent to the Unit's sides, front, and top. This
space is required to allow for proper ventilation of the Unit. At least 3
inches of space is required behind the Unit for cabling and airflow.
Position the Unit so adequate space is provided on both the left and
right sides to open the doors. Alternately verify that the Unit can be
moved (or rolled) to an open area where the doors can be fully
opened. The left and right doors must be able to swing open 90º to
load ticket stock or to perform routine maintenance.
ADP 4100 Printer Installation and Operators Manual, April 2007