Table of Contents
Advertisement
Loading ARC Ticket Stock 3000
Loading ARC Ticket Stock in Bin 1
ARC ticket stock must be loaded in Bin 1. Bin 1 is the
upper bin of the secure document bin. To locate Bin 1
on the printer, see figure 5. The bin holds a maximum
of 500 documents.
Note: In this procedure, you remove documents from
their boxes. To ensure documents load correctly, do not
turn them before inserting them into the printer.
1. Ensure printer is powered on (straight line on power switch is pressed down).
2. Unlock the secure ticket bin by turning the key clock wise. Then open the door by swinging it away from
the printer.
3. Remove approximately half the stock (500 coupons) from the ticket box. To ensure you have the right
amount of cards, add 499 to the stock control number of the first card in the stack. Then separate at the
perforation immediately following that coupon. Be careful not to turn the cards as they are removed from
the box.
Caution: Stock will not feed, properly if more than 500 coupons are loaded in the bin.
4. Place the coupons into Bin 1 (upper bin), so that the mag stripe faces the inside of the bin.
5. Grasp the first coupon and pull it into empty portion of Bin 1 (towards the back of the printer). Then roll it
until the printed side is facing up.
6. Hold coupon at an angle level with the prefeed slot. The prefeed slot is located directly below the green
release lever.
7. Push coupon firmly into the prefeed slot until the staple stub can no longer be seen. Release the coupon as
soon as you hear the motor start. The printer will automatically load the stock.
Note: If the motor runs and the coupon does not move, pull coupon out of slot. Allow motor to stop then
reinsert coupon into prefeed slot until staple stub is no longer visible.
8. Tug gently on the coupon to ensure it loaded properly. If not, repeat steps 6 and 7 until coupons
load correctly.
9. Shut side door of printer and make sure latch is secure.
10. If you use the lockable Cover, reinstall it and lock it in place. (See the "Installing Lockable Cover" section
on page 11 for instructions.)
Loading ARC Ticket Stock 3100
Complete the following steps to load ticket stock into the 3100 printer.
1. Remove the top flaps of the stock boxes at the perforations.
Note: It is not necessary to remove the stock from the box.
2. Place ticket stock in Bin #1, with the magnetic stripe towards the inside of the stand.
3. Place itinerary stock in Bin #2, with the white staple stub to the left if the first document is green side up, or
staple stub to the right if the first document has white side up.
Front of
Printer
ARC
ticket stock
Figure 5: Loading ARC Ticket Stock
8
Bin 1
Prefeed
slot
Advertisement
Table of Contents
