Sub-Zero 500 series Planning And Installation Manual page 9

in to cabinet trim (top view)
Figure 25
Back of Sub-Zero lht
Side of
Sub-Zero Unit
- t
Figure 26
Metal side panel fitted
up to cabinet trim (top view)
Sub-Zero Unit
- t
2 4 "
Figure 27
Remove the inner grille panel
assembly (refer to Figure 9
on page 14) and remove the
top two corner screws and
pull away the top frame. See
Figure 28.
Lay the remaining panel
assembly on a flat surface
and insert the panel insert
into position in the grille
frame as shown in Figure 28.
Reattach the top frame and
install the inner grille panel
assembly back onto the unit.
See Figure 9 on page 14.
If the doors are out of adjust-
ment, the top or bottom hinge
may be adjusted by removing
and discarding the two small
shipping stews. See Figure
29. The top door hinges can
be adjusted left to right and
in or out by loosening the
three allen head screws.
The bottom door hinge is
equipped with two adjustment
Figure 30.
Figure 29
Figure 30