Sub-Zero 500 series Planning And Installation Manual
  1. Manuals
  2. Brands
  3. Sub-Zero Manuals
  4. Refrigerator
  5. 500 Series
  6. Planning and installation manual
Sub-Zero 500 series Planning And Installation Manual

Sub-Zero 500 series Planning And Installation Manual

Hide thumbs Also See for 500 series:

Advertisement

Table of Contents

See also: Service Manual , Information Manual
N
B
U
Planning
and
Installation
Guide
F
A
0
R
E
R
G
E
R
N

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 500 series and is the answer not in the manual?

Questions and answers

Related Manuals for Sub-Zero 500 series

Summary of Contents for Sub-Zero 500 series

  • Page 1 Planning Installation Guide...
  • Page 2 90 degrees, you provided. The water line should be may have to move drawers All Sub-Zero units are routed up through the floor pages ZOA and IOB, Figures or crispers slightly to clear within %” from the back wall...

  • Page 3: Integrating Cabinetry

    Integrating Cabinetry The beauty of a built-in Sub-Zero is its ability to easily accept decorative panels on the front, side or grille area. Optional steel door panels MODEL B (width) (height) are available from Sub-Zero 67 ‘%6” in three colors - almond, stainless steel and white.

  • Page 4: Installation Instructions

    X ‘2g3h6” Panels must be %I” thick around the perimeter and routed to allow for %I” edge, except for Model 245, which The installation of a Sub-Zero requires is an easy task if you have 11x36 done the necessary prepara- 12 X The Sub-Zero 11”...
  • Page 5 The space behind grille. See Figure 7. assembly, the inner grille must be secured in place along the top of the Sub-Zero panels assembly must first be with a solid soffit or wood between the unit and the removed.
  • Page 6 For a finished look to the The rear levelers (rollers) are place. All full size Sub-Zero Sub-Zero install the toe plate adjusted from the front of the models are equipped with as illustrated in Figure 16.

  • Page 7: Panel Installation

    The molding easily comes off removed you can easily piece of tape to replace handle, screws and by using a All Sub-Zero units easily remove the door screws on pull it away from the handle. trim molding. The molding both the refrigerator and...
  • Page 8 Figure 2 1. Anchor the back portion of the side panel with Figure 23 decorative screws or nails. Refer to Figures 23-27. Sub-Zero Umt We do not recommend the up to cabinet trim (top vlew) use of adhesives. Pan Head Frame...
  • Page 9 Remove the inner grille panel assembly (refer to Figure 9 on page 14) and remove the Back of Sub-Zero lht top two corner screws and pull away the top frame. See Side of Figure 28. Sub-Zero Unit If the doors are out of adjust-...
  • Page 10 Nominal Overall Width of Sub-Zero 23%” to Rear of Sub-Zero Main Frame Door Open @ 90’ Figure C This overall view of a unit, its door and the relationship to a counter, a built-in wall appliance or corner shows how a filler strip may prevent...
  • Page 11 actual size drawings These Figure A offer you the opportunity to better understand unique Optional situations you may face in Extended some of your installations. Handle The page can easily be removed and photocopied or Panel used for your own tracings. Panel Figure A shows the Full-Length...
  • Page 12 Installation Check List 4.6 cubic feet to 30. The what it takes to plan for and complete inventory of models install a Sub-Zero. If you is on pages 4-9. Each Sub-Zero is protected would like our colorful Full We offer the finest warranty...

  • Page 13: Installation Checklist

    (Page 14) door to move left to right or The importance of the properly? in and out. installation of your Sub-Zero Once the adjustments are Cl Is toe plate installed? cannot be overemphasized. The proper installation of made be sure to tighten the...

  • Page 14: Fuli-Size Models

    H 73” W 36” D 24” Door Swing Clearance: 36?16~ All Freezer Door Panel: H 58%“~ W 34%” Dimensions Sub-Zero offers a complete line of built-in refrigeration Energy Usage options for your design alter- 470 kwh/$39/Annually* H 73” W 36” D 24”...
  • Page 15 Refrigerator/Freezer Dimensions Refrigerator/Freezer 36” 24” Dimensions Minimum /-/eight Required: Overall Size: 84” 36” 24” Door Swing C/earance: Refrigerator/Freezer Minimum /-/eight Required: Door Pane/s: 82%” Dimensions Door Swing C/earance: 20%” 34%” Door Pane/s: Energy Usage W 30” D 24” 735 kwh/$6l/Annualiy* Minimum Height Required: Storage Information Energy Usage...
  • Page 16 Refrigerator/Freezer with Ice and Water Refrigerator/Freezer Dispenser Dimensions Dimensions Overall Size: Overall Size: H 84” W 48” D 24” H 84” W 48” D 24” Minimum l-/eight Required: 82%” 82%” Door Swing Clearance: 29w Door Swing Clearance: 29%” Door Panels: Door Panels: H 67??16”x w 1715h6”...
  • Page 17 Refer to Figure A, Diffused Lighting. for easy installation. are standard on Sub-Zero’s Page 1OA for panel sizing Door Stop Kit. For instal- Sub-Zero’s overhead lighting seven full-size units.

  • Page 18: All Refrigerator

    All Freezer with Auto Defrost Dimensions Overall Size: H 3313h6” W 23%” D 24” Door Swing All Refrigerator Door with Auto Defrost Dimensions Energy Usage 482 kwh/$4O/Annually* Refrigerator/Freezer Storage lnformatlon with Auto Defrost Freezer: Panel: Door of Storage 4.6 cu. ft. 30”X w 23%”...

  • Page 19: Planning Information

    When insta//ing cabinets with six inch bases, add two inches to the minimum height (FOOTNOTE: detailed above, if you want to make Me base of the Sub-Zero even with the cabinets.) Locate Electrical 6”...

  • Page 20: Undercounter Models

    Door Swing C/earance: 253W’ Door Pane/: H 30”X w 23%” Ice Maker Usage Energy Dimensions 337 kwh/$28/Annually* Sub-Zero undercounter H 3413&?.” W 17w D 23%” Storage lnformatlon refrigerators, freezers, com- Door Swing C/earance: 1lW bination units and ice makers Refrigerator: Door Panels: all accept decorative door 4.4 cu.

Table of Contents