GREAT PLANES Sequence 1.20 Instruction Manual page 15

❏
8. Once you've made the arming plug, decide which of
the three precut locations in the fuselage side you will use
for mounting a Deans female Ultra Plug to serve as the
receptacle. Solder the plug in-line between one of battery
leads. Solder on any additional wire so the battery and ESC
will reach.
❏
9. Mount the ESC to the ESC mount with three #4 x 1/2"
Phillips screws and #4 fl at washers. After mounting the ESC,
temporarily remove the screws, harden the holes with a few
drops of thin CA, allow to harden, then remount the ESC.
❏
10. If using the arming plug, carefully cut the covering
from the side of the fuselage over the location you will use for
the receptacle. Securely glue the receptacle plug into place
with the plywood doubler.
❏
11. Make battery straps from the included Velcro strips
and guide them in and out of the slots in the battery fl oor
(the rear strap can be reached with your fi ngers under the
rear of the fl oor, but the front strap will require a piece of
wire to pull it up through). Apply strips of the rougher, "hook"
side of Great Planes adhesive Velcro to the battery fl oor and
apply strips of the softer, "loop" side to the batteries. Then
test mount the battery into position just to see how it all fi ts.
15