Finish The Cowl; Hook Up The Rudder And Elevators - GREAT PLANES Sequence 1.20 Instruction Manual

Finish the Cowl

❏
1. If using a glow engine, mount the muffl er and make any
additional cuts necessary—you may have to cut through the
cowl ring, but this won't weaken the cowl because the ring
will be braced by the fuselage when bolted into position.
❏
2. Make any other cuts/holes necessary for the needle
valve, glow plug and fueling lines.
❏
3. Once all the cowl holes have been cut fi nal-sand the
edges of all cuts with 320-grit or 400-grit sandpaper.
❏
4. If using a glow engine, lightly coat the cowl ring with
thinned epoxy or fuelproof paint.

Hook Up the Rudder and Elevators

❏
1. Same as was done with the ailerons, give a good pull
on the rudder and look at the hinges to make sure they are
all secure. Use thin CA to wet any hinges that look dry.
❏
2. Making sure the trims and sub trims are centered, use
your transmitter to center the rudder servo.
❏
3. Enlarge the second-from-the-outer holes in a Great
Planes 3" [150mm] double-side servo arm (GPMM1165)
with a 7/64" [2.8mm] drill. Mount the servo arm to the servo.
Threaded
Cable Coupler
Brass
Cable Swage
❏
4. Fit the aft rudder servo rail into position in the fuselage
and adjust it to fi t the rudder servo. Securely glue the rail in
22
4-40x1/2"
SHCS
4-40 Ball
Link
Stand-Off
Great Planes
3" Double-Side
Servo Arm
4-40 Nut
(Use threadlock)