Base Control Console; Electrical Panel - Skyjack SJ 3219 Operating Manual

Section 2 - Operation

2.5-4 Base Control Console

This control console is located at the rear of the base.
It contains the following controls:
1
2
3
Figure 2-2. Base Control Console
1. Lower/Neutral/Raise Switch - This switch controls
" raising or "
"
2. Off/Platform/Base Key Switch - This three-way
switch allows the operator to turn "
to aerial platform or to activate either "
or " " base controls.
3. Emergency Stop Button - This button "
when depressed, disconnects power to the control
circuit.
SJIII Compacts & Conventionals
" lowering of platform.
" off power
" platform
December 2007

2.5-5 Electrical Panel

This panel is located in the hydraulic/electric tray. It
contains the following controls:
1
Figure 2-3. Electrical Panel
1. Circuit Breaker Resets - In the event of power
overload or positive circuit grounding, the circuit
breaker pops out. Push the breaker back in to
reset.
2. Hourmeter - This gauge records accumulated
operating time of the aerial platform.
2.5-6 Disc Brake System
The brake system is located at the rear of the base.
The brakes must be manually disengaged before
pushing, winching or towing. Refer to
for procedure on how to release brakes manually. The
system contains the following controls:
1
",
Figure 2-4. Disc Brake System
1. Brake auto reset valve plunger
2. Brake hand pump
Component Identification
2
Section 2.14-2
2
Page 17
TM