Base Control Console - Skyjack SJ30 AJE Operating Manual

Section 3 – Familiarization

3.3-3 Base control console

This control console is located in the panel mounted
in the control compartment. It has the following
controls:
Function enable switch - This momentary
1
switch, when held in function enable position,
allows base control functions to operate.
Circuit breakers - In the event of a power
2
overload or positive circuit grounding, the circuit
breaker pops out. Push breaker back in to reset.
Hourmeter - The display shows accumulated
3
operating time, battery level and error codes.
Refer to service manual for error codes.
Emergency power switch - This switch, when
4
held in emergency power position, allows base
control functions to operate using emergency
power unit.
Emergency stop button - This red "mushroom-
5
head" pushbutton disconnects power to control
circuit.
7
Base/off/platform key switch - This three-way
6
selector switch allows operator to activate base
control console, turn off power to MEWP , or
activate platform control console.
7
Jib rotation switch (if equipped) - This switch
7
controls left or right rotation of jib.
213213AAA
24
2
1
15
14
13
11 12
Figure 07 Base control console
3
4
5
TM
6
7
8
10 9
7
Jib up/down switch - This switch controls up or
8
down movement of jib.
Boom extend/retract switch - This switch
9
controls extension or retraction of fly boom.
7
Riser raise/lower switch - This switch controls
1 0
raising or lowering of riser.
7
Platform rotation switch - This switch controls
1 1
left or right rotation of platform.
7
Platform leveling override switch - This switch
1 2
overrides automatic leveling of platform and
controls tilting up or tilting down of platform.
7
Turret rotation switch - This switch controls left
1 3
or right rotation of turret.
7
Boom raise/lower switch - This switch controls
1 4
raising or lowering of main boom.
7
Overload light - This red light indicates overload
1 5
status. Refer to Section
Manual Storage Box
3.4-7.
SJ30 AJE SJ30 ARJE