HP ProLiant ML350 Gen9 User Manual page 81

For tower models, open and remove the bezel
o
For rack models, if installed, remove the security bezel
o
page 30).
Power down the server (on page 29).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 33).
o
Remove the access panel (on page 31).
5.
Remove the air baffle (on page 33).
6.
Open each of the processor locking levers in the order indicated in the following illustration, and then
7.
open the processor retaining bracket.
("Remove the tower bezel" on page 30).
("Remove the security bezel
Hardware options installation 81
(optional)" on