Drive Options; Drive Installation Guidelines - HP ProLiant ML350 Gen9 User Manual

SFF configuration
o
Install the fan cage (on page 37).
10.
Install the air baffle (on page 34).
11.
Install the access panel (on page 32).
12.
Slide the server into the rack.
13.
Connect each power cord to the server.
14.
Connect each power cord to the power source.
15.
Power up the server (on page 29).
16.
Install the security bezel
17.

Drive options

For a list of drive configurations supported in this server, see "Device numbering (on page 20)."
The embedded HP Dynamic Smart Array B140i Controller only supports SATA devices. For SAS drive
installation, install an HP Host Bus Adapter or an HP Smart Array Controller board option.
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/go/qs).

Drive installation guidelines

When adding drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
Populate drive bays, based on the drive numbering sequence. Start from the drive bay with the lowest
device number
•
All drives grouped into the same drive array must meet the following criteria:
They must be either all SAS or all SATA.
o
They must be either all hard drives or all solid state drives.
o
("Security bezel
("Device numbering" on page 20).
option" on page 48).
Hardware options installation 56