Table of Contents
Advertisement
COMPLETING THE COMBO
INSTALLING THE AMP
1. Place the cabinet upside down on the table, propping it up on a couple of books or something
so the handle doesn't touch the table. Carefully set the amp in place, with the black label facing
down.
Press the bottom of the amp flat against the cabinet Front.
288
288
2. Place a finish washer (Part #WA10) around the shaft of a #6x1-1/4" sheet metal screw (Part
#SC69). Run the screw through one of the holes in the cabinet face. Use a #2 Philips driver,
NOT a screw gun! If we all did our jobs well, the screw will line up perfectly with the hole in the
chassis and will dig right in. Just start the screw, then repeat for the other three screws.
hold the amp tight to the cabinet and drive the screws in until you feel them pull the amp tight.
DO NOT OVERTIGHTEN THESE SCREWS or they will strip out the chassis.
289
290
84
Now
289
290
Advertisement
Table of Contents
