Table of Contents
Advertisement
37. Check the box for overall squareness: Set the cabinet on its back and drop the baffle board into
place. Does the opening seem reasonably square? If not, clamp the baffle board into the acute
corner as shown.
(We demonstrate this here on a 1x8 speaker cabinet shell.) This will pull the
183
whole box into perfect square. Now tighten all eight cabinet screws.
other clamp to hold the joints tight as you drive the screws home. Do not over-tighten! You will
only sink them too deep into the side, or spin them out, or worst, break off the head. Proceed
carefully with a screw driver, or a cordless screw gun with the clutch set low (1, 2 or 3).
183
38. Move the bar clamp to the lower Port and clamp it tightly to the Bottom.
place, flush with the tops of the rear cleats or a hair higher.
185
39. Drill six holes 5/64 x 1-1/8" deep through the ports where marked and into the cleats.
187
184
184
186
186
59
If necessary, use the
Fit the upper Port in
185
187
Advertisement
Table of Contents
