Table of Contents
Advertisement
9.
Wiring the PCB: Once the PCB is affixed to the chassis you can attach the transformer wires. All
of the wires will pass around the side of the PCB, and you will solder them on the component side
of the board.
a. Output transformer: Place the red wire into the square hole of P1, and then the blue wire to
the round hole of P1. Solder both connections.
78
b. Power transformer: Place the black wires into the holes of P4; it doesn't matter which wire
goes in which hole.
wires into the holes of P3.
but MAKE SURE YOU MATCH THE COLOR TO THE CORRECT NUMBER! Solder all the wires
in their respective holes.
79
81
10. Grounding Wire (Part # CB10.3): Strip about 1/4" (6mm) of insulation off both ends of one of
the 4cm hookup wires. Using your needle nose pliers, bend a small hook in one stripped end of
the wire.
Thread the hook through the small hole on the grounding lug (Part # CB20) and crimp
82
it tight with your pliers.
Place the red wires into the holes of P2
79
In each pair, it does not matter which wire goes in which hole,
81
80
Solder that connection.
83
31
78
, and then place the brown
80
Put this assembly aside until next step.
84
Advertisement
Table of Contents
