Table of Contents
Advertisement
5.
Label (Part # PL11): Clean the front of the chassis with a clean rag moistened with isopropyl
alcohol, denatured alcohol, or rubbing alcohol.
dry completely. Be careful NOT TO TOUCH the face AT ALL
after cleaning. The oil on your fingertips will leave prints
that will interfere with the bond of the label. Test fit the
label, then peel off the back and carefully set it in
place.
GET IT RIGHT THE FIRST TIME! YOU WILL
69
NOT BE ABLE TO RE-POSITION THIS LABEL! Line up
the bottom edge of the label with the bottom edge of
the chassis; then align some of the chassis holes, drop it
in place, and rub it down firmly over the entire surface.
68
6.
LED bezel (Part # SK05): Install the plastic LED bezel into its hole on the front of the chassis
(through the label).
70
place.
70
69
It goes in the hole to the right of the ZDL logo. It should easily snap into
28
Clean it thoroughly, and allow any liquid to
68
TIP: If the label
is slightly misaligned over
one of the edges or holes use
a razor blade or xacto knife to
trim off the excess.
Advertisement
Table of Contents
