Table of Contents
Advertisement
7. After the lugs have adequately cooled, carefully squeeze the crimp rings back down onto the
wire.
This should be snug enough to hold the wire in place, but not so tight that you damage
240
or cut through the insulation!
240
8. Carefully slide the plastic sleeve along the wire and over the contacts.
242
9. Slide the jack barrel along the wire and over the jack. Screw it on tight.
the clamp or vise and this baby is done.
243
10. Test the continuity of the cable with your multimeter. Set your meter to the continuity setting (or
Resistance setting).
a. Test for continuity from the jack tip (the positive point) to the end of the wire with writing. A
continuity tester will beep; a resistance meter should show very low resistance, like, less than
one ohm.
241
241
243b
243b
72
242
Take the jack out of
243
Advertisement
Table of Contents
