Table of Contents
Advertisement
13. Wiring the IEC power receptacle:
WARNING:
If you make a mistake here, you could expose yourself or others to electric
shock. Double check all your connections.
a. Retrieve the lengths of wire that you cut off the power transformer earlier. Cut each of the two
black wires to 4-1/4" (10.5cm) long.
end of both wires.
95
b. Now twist the two wires together, to within about 3/8" of each end.
pair to the holes labled P5, IEC jack.
97
c. Solder the end of the wires to the IEC power receptacle, to the two lugs shown in the picture.
It doesn't matter which wire goes to which lug, JUST MAKE SURE YOU SOLDER THEM TO
THE CORRECT TWO LUGS! Mind the picture.
99
Strip about 3/16" (4-5mm) of insulation from each
95
Tin each end (don't use too much solder).
96
98
98
35
96
97
100
100
Solder one end of the
99
Advertisement
Table of Contents
