Table of Contents
Advertisement
86
c. Now solder the wires to the lug. Be careful not to use too much heat or the lug could start
melting out of the plastic.
87
d. Bend both wires slightly forward and push the power receptacle through the chassis. BE SURE
TO INSTALL IT WITH THE CORRECT SIDE UP (look at the picture).
could take some wrenching to get it to seat. Once it is seated properly, you can very gently
bend the four retaining tabs of the power receptacle up if you want to ensure a tighter fit.
88
87
89
33
It may be a tight fit; it
88
89
Advertisement
Table of Contents
