Attaching A Uhf Portable Tuner; Microphone System) - Sony MSW-970 Operation Manual

Screws removed
in step 1
CAC-12
3
Open the CAC-12 and remove the microphone
adaptor.
Open the CAC-12.
Loosen the screw.
1) Attach the microphone adaptor when using a small-
diameter external microphone.
4
Place an ECM-672 electret condenser microphone in
the CAC-12.
Tighten the screw.
5
Connect the microphone cable to the AUDIO IN CH1
or AUDIO IN CH2 connector.
Set the LINE/MIC/+48 V ON switch to +48 V ON if
you use an external power supply type microphone.
Otherwise, set the switch to MIC.
122
Audio Input System
Microphone
1)
adaptor
Close the CAC-12.
ECM-672 or similar
microphone
f
Note
When you detach the CAC-12 Microphone Holder once
you have attached to the camcorder, be careful not to lose
the two screws fixing the CAC-12. After detaching the
CAC-12, be sure to put the two screws back into their
original places (see the figure illustrating the step 1
operation).
7-5-3 Attaching a UHF Portable
Tuner (for a UHF Wireless

Microphone System)

To use a Sony UHF wireless microphone system, fit one of
the following UHF portable tuners.
• WRR-855A/855B UHF Synthesized Tuner Unit
• WRR-860/862 UHF Portable Tuner.
For each of these UHF portable tuners, use the following
attachment procedure.
For details, refer to the UHF portable turner manual.
Fitting the WRR-855A/855B
You can use the WRR-855A/855B UHF Synthesized
Tuner Unit simply by inserting it into the slot in the
camcorder, and fastening the fixing screws.
1
Undo the four fixing screws holding the cover of the
slot, and remove the cover.
2
Insert the WRR-855A/855B, and fasten the four fixing
screws.