Mounting The Lens - Sony MSW-970 Operation Manual

3
Turn the eyepiece locking ring clockwise until its
"LOCK" arrow points at the red mark on the
viewfinder barrel.
Note
When the eyecup is worn out, replace it with a new one
(service part number 3-723-079-03).

7-3 Mounting the Lens

To mount the lens, proceed as follows:
For information about using the lens, refer to the lens
manual.
5 4 2
Mounting the lens
1
Push the lens locking lever upward and remove the
lens mount cap from the lens mount.
2
Align the center slot in the lens mount with the center
pin on the lens and insert the lens into the mount.
3
Holding the lens in place, push the lens locking lever
downward to mount the lens.
Note
If the lens is not firmly locked, it may come off while
the camcorder is being used. This could cause a serious
accident. Make sure the lens is firmly locked. It is
recommended that the lens mount securing rubber
(supplied) be put on the lens-locking lever as
illustrated above.
4
Connect the lens cable to the LENS connector.
Note
Connecting a cable to the LENS connector while in
powered status may cause a malfunction or damage the
unit. Turn off the power before you make a connection
with the LENS connector.
5
Secure the lens cable with the cable clamps.
Lens mount
1 3
securing rubber
Mounting the Lens
119