Saving And Loading Scene Files; Saving A Scene File - Sony MSW-970 Operation Manual

P00 USER LOAD
DISPLAY MODE
001.USER1
002.USER2
003.NO FILE
004.USER4
005.USER5
5
Turn the MENU knob to move the
desired file number to be loaded, and press the MENU
knob.
The message "LOAD OK? YES
P00 USER LOAD
LOAD OK?
DISPLAY MODE
001.USER1
002.USER2
003.NO FILE
004.USER4
005.USER5
6
To carry out the load, move the
press the MENU knob.
To cancel, press the MENU knob leaving the
pointing to "NO."
The ACCESS indicator lights.
When the load is completed, the message
"COMPLETE" appears and the ACCESS indicator
goes off.
The USER FILE page appears again.
7
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
If data cannot be loaded
If one of the following error messages appears during or
after the load operation, then the data was not loaded.
Data load error messages
Error message Cause
NO MEMORY No "Memory
STICK (flashing) Stick" is inserted.
MEMORY STICK Circuit or
ERROR "Memory Stick"
(flashing) fault.
OTHER The "Memory
MODEL'S FILE Stick" contains
(flashing) data that cannot
be loaded into this
camcorder.
ESC
: ALL
JAN/01/04
JAN/15/04
FEB/05/04
FEB/20/04
b
mark to the
b
NO" appears.
ESC
YES NO
: ALL
JAN/01/04
JAN/15/04
FEB/05/04
FEB/20/04
b
mark to "YES" and
b
mark
Action
Insert or reinsert the
"Memory Stick."
Recheck, and
consult your Sony
representative.
Do not try to load
data saved from
another camcorder.
6-2 Saving and Loading
Scene Files
You can save various settings for shooting a particular
scene as a scene file. Loading the scene file, you can
quickly recreate setup conditions suitable for the scene.
You can save up to five scene files in the camcorder
memory and up to 100 scene files in a "Memory Stick."
You can also load data from the "Memory Stick" into the
camcorder memory.
Data that can be saved in a scene file
You can save the following data in a scene file:
• Values adjusted using the PAINT menu (except the items
that return to the default values when power is on, such
as TEST OUT SELECT)
• Shutter speed settings made in the standard mode and
ECS mode
The white balance data can be loaded only when the
SCENE WHITE DATA setting on the REFERENCE page
of the FILE menu is ON.

6-2-1 Saving a Scene File

Proceed as follows to save a scene file in the camcorder
memory or the "Memory Stick."
To save a scene file in the "Memory Stick," insert the
"Memory Stick" before starting the operation.
1
In the TOP menu, select the FILE menu.
2
Turn the MENU knob until the SCENE FILE page
appears, then press the MENU knob to select the page.
Alternatively, select "SCENE FILE" on the
CONTENTS page to display the SCENE FILE page.
SCENE FILE page
F04 SCENE FILE
s1 :STANDARD
s2 :STANDARD
s3 :STANDARD
s4 :STANDARD
s5 :STANDARD
sSTANDARD
SCENE RECALL
SCENE STORE
F.ID:
If you want to set a file ID for the data to be saved
Set the file ID before going to step 3.
For details on setting the file ID, see "Setting the file
ID" on page 111.
TOP
: EXEC
: EXEC

Saving and Loading Scene Files

109