Joyner JNSZ1600QL Owner's Manual page 75

2) The removal and installation of oil pan
Removal ： — —Loosen drain plug and drain oil
——Loosen eighteen M6
——Take out the sealing gasket of oil pan
——Check if the left and right reinforced plates are still clipped on the back face of oil pan
flange face
Fig.98
Installation ： ——Apply locite 598 sealant and G Y409 anaerobic sealant on the joint place between flange
surface of oil pan of cylinder body and oil pump case, and carrier of real oil seal.
——Put the new rubber seal gasket on the cylinder body and have the two sides of sealing
gasket enter into the grooves of carrier of real oil seal and oil pump.
——Install the oil pan with the two sides of sealing gasket in the grooves of oil pan.
——Screw the bolt by hand (the bolt with washer indicated in the figure100 is precedent.)
Fig.100
——Tighten bolts to 5.0—8.0Nm according to the sequence of the upper figure.
： ： ： ：
× 2 0 bolts
Fig.99
74