Crankshaft Pulley Removal And Installation - Joyner JNSZ1600QL Owner's Manual

——Remove seal gasket and shot nail from upper timing gear cover.
——Remove crankshaft pulley.
——Loosen and remove 2 bolts for lower timing gear cover assembly.
——Remove lower timing gear cover and seal gasket assembly.
——Remove shot nail and seal gasket from lower timing gear cover. Installation
——Clean lower timing gear cover.
——Mount new seal gasket with shot nail or glue on lower timing gear cover.
——Install lower timing gear cover and seal gasket on crankshaft
tighten to 9.0—11Nm.
——Clean upper timing gear cover.
——Mount new seal gasket with shot nail or glue on lower timing gear cover.
——Install upper timing gear cover seal gasket with 2 bolts on cylinder block
is 9—11Nm.

. Crankshaft pulley removal and installation

【 3 】
Fig.30
：
Removal — —If engine is equipped with starter
starter.
——Block flywheel ring gear with a appropriate screwdriver or lever, preventing crankshaft
from rotating.
——Loosen crankshaft pulley mounting bolts
——Pull out pulley, if necessary, puller may beused.
， ×
r emove three M10 3 0 or M10
， r emove bolt and cushion block.
42
：
，
f inger screw in 2 bolts and
， t ightening torque
×
3 5 bolts and remove