Martin MAC III Profile User Manual page 60

Short code Full-text message
PCDE PAN/TILT CALIBRATE DATA PCB (s/w versions prior to ver. 1.3)
Unable to read/write data to external EEPROM board (calibrate date) on yoke
PSER PAN SENSOR ERROR
PTCM PAN/TILT SENSOR CAL MISSING
The pan/tilt sensors are not calibrated.
PTCO PSU TEMP CUTOFF
Ballast in thermal cutoff
PTCS PAN/TILT CALIBRATE SENSOR (s/w versions prior to ver. 1.3)
Pan/tilt sensors not calibrated
PTER PSU TEMP HIGH
The temperature on a PCB in the power supply unit or ballast is high. A fan might be defective or the
ambient temperature may be too high.
R1ER GOBO WHEEL 1 ROTATION ERROR
R2ER GOBO WHEEL 2 ROTATION ERROR
SHUE SHUTTER ERROR
SHNA SHUTTER NOT ADJUSTED
No shutter adjustment data in EEPROM
SLER SAFETY LOOP ERROR
Lamp safety loop circuit activated: the lamp access hatch is open or lamp is too hot
SSTO SYSTEM STATE TIMEOUT
Failure to communicate with module during self-check at startup. Service intervention required.
Fixture control possibly disabled, depending on nature of error.
TIER TILT ERROR
TINA TILT NOT ADJUSTED
Tilt needs to be adjusted by a qualified service technician.
TSER TILT SENSOR ERROR
UECH UPLOAD ERROR CHARGER
Could not upload new firmware to the Charger module.
UECM UPLOAD ERROR CMY
Could not upload new firmware to the CMY module.
UECO UPLOAD ERROR COOLING
Could not upload new firmware to the Cooling module.
UEEF UPLOAD ERROR EFFECT
Could not upload new firmware to the Effects module.
UEPT UPLOAD ERROR PAN/TILT
Could not upload new firmware to the Pan/Tilt Focus module.
UEPU UPLOAD ERROR POWER UNIT
Could not upload new firmware to the Power Unit module.
UEUI UPLOAD ERROR UI
Could not upload new firmware to the User Interface module.
UEZF UPLOAD ERROR ZOOM/FOCUS
Could not upload new firmware to the Zoom Focus module.
UPLB UPLOAD ERROR ON BALLAST (s/w versions prior to ver. 1.3)
UPLC UPLOAD ERROR ON COOLING (s/w versions prior to ver. 1.3)
UPLD DMX UPLOAD ERROR
An error occurred during upload via DMX. Check cabling and connections, and then restart.
UPLE UPLOAD ERROR ON EFFECT (s/w versions prior to ver. 1.3)
UPLM UPLOAD ERROR ON CMY (s/w versions prior to ver. 1.3)
UPLP UPLOAD ERROR ON PAN/TILT (s/w versions prior to ver. 1.3)
UPLU UPLOAD ERROR ON USER INTERFACE (s/w versions prior to ver. 1.3)
UPLZ UPLOAD ERROR ON ZOOM/FOCUS (s/w versions prior to ver. 1.3)
YEER YELLOW ERROR
YT W YOKE TEMPERATURE TOO HIGH
Yoke PCB temperature > 85° C
YTER YOKE TEMP HIGH
The temperature on a PCB in the yoke is high. A fan might be defective or the ambient temperature
may be too high.
YTCO YOKE TEMPERATURE CUTOFF
Yoke PCB temperature > 95° C
Table 4: Error messages