Factory Settings; Fixture Information Readouts - Martin MAC III Profile User Manual

warnings but error messages can still be read when the display is activated manually. In both Start and
Silent modes, the status LED in the jog wheel lights amber to indicate a warning and red to indicate an
error.

Factory settings

FACTORY SETTINGS lets you restore the fixture's default setup options. Effect calibration is not affected,
so any effects that have been re-calibrated will not be returned to factory calibration settings.

Fixture information readouts

The following fixture information can be called up in the display:
• FIRMWARE VERSION displays the currently installed fixture
software version.
• POWER ON TIME provides two counters:
- The TOTAL POWER ON counter is not user-resettable and
displays total hours powered on since manufacture.
- The RESETTABLE POWER ON counter is user-resettable
and displays the number of hours the fixture has been
powered on since the counter was last reset.
• LAMP ON TIME provides two counters:
- The TOTAL LAMP ON counter is not user-resettable and displays total hours the lamp has been
powered on since manufacture.
- The RESETTABLE LAMP ON counter is user-resettable and displays the number of hours the lamp
has been powered on since the counter was last reset.
• LAMP STRIKES provides two counters:
- The TOTAL LAMP STRIKES counter is not user-resettable and displays the total number of lamp
strikes since manufacture.
- The RESETTABLE LAMP STRIKES counter is user-resettable and displays the number of lamp strikes
since the counter was last reset.
• AIR FILTERS provides an alert feature for service interventions:
- The RESETTABLE AIR FILTER counter displays the total number of hours the fixture has been
powered on since the alert timer was last cleared.
- SET TIME ALERT lets you set the number of hours from 1 to 750 you want the fixture to be powered on
before a service alert appears in the display. If you set this figure to 0, the time alert is disabled.
- CLEAR RESETTABLE AIR FILTER lets you reset the resettable air filter counter to zero after
completing service work.
• FIXTURE MAC ID displays the fixture's factory-set MAC (Media Access Control) address.
• RDM UID displays the fixture's factory-set unique ID for identification in RDM systems.
• FANS SPEED provides separate status readouts from the fixture's cooling fans.
• TEMPERATURE provides a fixture temperature status readout.
• POWER UNIT provides the following readouts:
- MAINS VOLTAGE displays a mains power voltage readout
measured at the fixture's mains power input.
- LAMP VOLTAGE, LAMP CURRENT and LAMP WATTAGE
display readouts measured at the fixture's lamp terminals.
- LAMP STATE gives a lamp status readout.
- IGNITER STATE gives an igniter (starter) lamp status
readout.
- INTENSITY indicates current lamp intensity.
• EVENT LOG VIEWER lets you view event logs in the fixture's
display panel. See "Event log" on page 33.
Control panel operations 19