5061
Cartridge drive assembly removal
Note: Drive assemblies must be removed in the following order until the desired assembly can be removed:
1.
Black
2.
Magenta
3.
Cyan
4.
Yellow
See
"Cartridge drive assembly (one drive assembly per package) Also order cable tie parts packet (P/N
40X1648)." on page 7-29
1.
Remove inner system board shield. See
2.
Remove the cartridge drive assembly mounting screws (A). Black is shown.
3.
Disconnect the cable (B) from the cartridge drive assembly.
4.
Note the location of the cable ties (C), and cut them. Yellow is shown.
5.
Remove the cartridge drive assembly.
Installation note: Be sure to replace all the cable ties.
4-38
Service Manual
for the part number.
"Inner system board shield removal" on page
4-48.