Fine Tuning Fold Test Sheet - Formax FD 2054 AutoSeal Operator's Manual

Make copies of this page on copy paper for fine tuning folds
Instruction For Lining Up Folds
1. Place a stack of these sheets into the feeder and fold
one (1) or two (2) sheets.
2. Take a folded sheet from the catch tray and lay it on
top of a pressure seal form lining the leading edge of
this sheet up with leading edge of the pressure seal
form.
3. If the folds on this test sheet do not line up with the
perforated folds on the form, the fold plates need to
be adjusted up or down to make the folds line up.
Refer to Fig. 1 for a "Z" fold and Fig. 2 for a "C" fold.
- If fold "A" on the test form is to the right of the perfora-
tion on the pressure seal form move the top fold plate
stop position up. If fold "A" is to the left move the top
fold plate stop position down.
- If fold "B" on the test form is to the right of the perfora-
tion on the pressure seal form move the bottom fold
plate stop position down. If fold "B" is to the left move
the bottom fold plate stop position up.
Leading Edge
h
Fig. 1 "Z" fold Form
22
Fig. 2 "C" Fold Form
Fold "A" Fold "B"
Fold "A" Fold "B"
Leading Edge
Leading Edge