Stacker Override - Formax FD 2054 AutoSeal Operator's Manual

Stacker Override

The FD 2054 automated stacker positions may need to be
overridden to accommodate different types of paper in order to
improve the outfeed stacking. The positions are preset at the
factory and should only be changed if needed.
From the Operator Settings screen select "Stacker Override",
and press the " " to select.
1. "Stacker Override Positions are preset by fold settings
only change if needed" will be displayed. Press the
" " to enter the stacker override setup or the "C" button
to exit.
2.
Using the " " buttons, select the standard fold that
the stacker position needs to be adjusted for. Press the
" " button to enter the selection.
3.
Select the paper size using the "
the " " button to advance.
4. Adjust the stacker wheel position up or down using the
" " buttons. The number shown "P1" is the factory
setting for the fold type and paper size selected.
5. Press the " " to save. To adjust stacker settings for ad-
ditional folds, repeat steps 1 through 4.
" buttons. Press
15