Inter-Function Delay - CipherLab 1663 User Manual

Note: Read the "Set Connection" barcode first, and then the "MAC ID" barcode within 10
seconds.
Instead of producing the "MAC ID" barcode, you may read the setup barcodes for entering the MAC
address.
Read the "Abort" barcode to cancel the operation at any time while reading setup barcodes for
the MAC address. If the MAC address has not been completed yet, reading the "Validate"
barcode can cancel the operation as well.
Usage:
1) Read the barcode above.
2) Read the "Hexadecimal
3) Read the "Validate" barcode on the same page to complete this setting.
Exit SPP Master Mode
To stop such re-connection, read "Reset Connection" or "Restore System Defaults" barcode so that
the current connection record (= MAC ID) will be cleared. Then, the scanner will restart itself
automatically. Go through the process in
connection.

2.3.2 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of milliseconds, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-function delay.
2) Read the "Decimal
milliseconds).
3) Read the "Validate" barcode on the same page to complete this setting.
Value" barcode on page 220 for the desired MAC address.
3.2.3 Connect to Dongle
Value" barcode on page 219 for the desired inter-function delay (in
Chapter 2 Selecting Output Interface
Enter MAC ID in
Hexadecimal...
to establish a new WPAN
Reset Connection
Inter-Function
Delay... (*0~254)
Update
71