Ack/Nak Timeout - CipherLab 1663 User Manual

1663 Barcode Scanner

2.7.3 ACK/NAK TIMEOUT

By default, the scanner sends data to the host without waiting for an ACK/NAK response
before sending more data. Specify a value, ranging from 1 to 99 in units of 0.1 second. If
no response within the specified period of time, the scanner will attempt to send the
same data two more times. If all attempts fail without any notification, data loss will
occur.
1) Read the barcode above to specify the time interval for the scanner to send data and
wait for a response from the host.
2) Read the "Decimal
scanner to automatically shut down after being idle for 1 second.
3) Read the "Validate" barcode on the same page to complete this setting.
ACK/NAK Error Beep
Note: We suggest enabling the error beep so that data loss is notified and the scanner
re-read data.
96
User Guide
Value" barcode on page 219. For example, read "1" and "0" for the
ACK/NAK Time-out
after ... (*0~99)
Enable Error Beep
*Disable Error Beep
Enter Setup