Table of Contents
Advertisement
Installation guide
Calibration setting:
w
Calibration settings should only be made when the val-
ues to be entered are known. The unit cannot perform
correct route calculations if incorrect values are en-
tered.
It is possible to provide calibration settings manually.
In the Service Mode, select r3X. IE:F:QT'IC#l using the right rotary
knob 0 and press to confirm.
Using the right rotary knob 0 select PKO FY and press to confirm.
Unit rotation can be selected in degrees by turning the right rotary
knob 0 and pressing to confirm.
w
Unit rotation corresponds to horizontal rotation. A positive
value means rotation of the front of the unit towards the
driver (LHD).
The unit inclination can now be selected in degrees by turning the right
rotary knob 0 and pressing to confirm.
w
Unit inclination corresponds to vertical inclination. A posi-
tive value means upward inclination of the front of the unit.
Subject to correction and technical modifications
18
Copyright by Becker GmbH, D-76303 Karlsbad
Advertisement
Table of Contents
