Table of Contents
Advertisement
Installation guide
11. Service Mode
In Service Mode, various functions can be checked in detail and the cal-
ibration can be modified.
Switch on the unit (see operation guide).
Enter code (see operation guide).
If the unit has already been calibrated, select the main navigation
menu by pressing the - button.
@
If the unit has not been calibrated, proceed as described in the after
next point.
Press the .
@ button again to access the system settings.
nd hold the : ~~~$$.
( multifunction button. Then press the
. .
multifunction button. This calls up the Service Mode.
following functions can be selected in the Service Mode:
r:35"'S :WF'L'~ - GPS function test
UX IWWT XW4 - function for deleting the calibration or for setting
a calibration
C:RL IERRT KN F: IL:E - display for calibration ride
VKK:ULE TEE-T - internal component test
qg-./g:lF:E - sensor function test
ziPEEI,:fl '[Ezi'r - voice test
C:iEMKi - demo mode selection
UEK KX1 - the status of the Navigation CD is displayed
By turning the right rotary knob 0, select the desired entry
(large letters) and press to confirm.
Subject to correction and technical modifications
16
Copyright by Becker GmbH, D-76303 Karlsbad
Advertisement
Table of Contents
