Table of Contents
Advertisement
Installation guide
8. Initializing GPS and Performing the Sensor Test
0
Connect the battery.
0
Switch on the vehicle ignition to initialize the GPS and to perform
the sensor test. Switch on Traffic Pro.
Enter code (see the operation guide for a detailed description).
n&on button and the
lf?~ multifunction
0
This calls up the menu for the initial GPS start-up and for the sen-
sor test.
0
Drive the vehicle forwards or backwards at varying speeds to con-
firm operation of the speed signal test.
w
The number under ~?=~s~L,
%r must change (even at a low
speed).
The number under SF- -xxx4 must not increase when idling or
pressing the accelerator when the vehicle is parked.
0
Engage the reverse gear for the reverse signal function test.
w
The arrows under C:! i:-.e~.t.i~:-i must change direction on
engaging the reverse gear.
0
When initializing GPS, the vehicle must be parked outdoors, while
ensuring that it has a clear view in all directions (not in the imme-
diate vicinity of buildings).
Subject to correction and technical modifications
10
Copyright by Becker GmbH, D-76303 Karlsbad
Advertisement
Table of Contents
