Table of Contents
Advertisement
3. General Operation
3.1. Switching On/Off
Press the
key.
ON
Additional options for switching on / off: Ignition.
To turn the unit on through the ignition key, the unit
must have been switched off via the ignition. After
switching off the ignition, the unit can be prevented
from switching off by pressing
within 3 seconds.
ON
Note
With the ignition off, the unit can be turned on using
the
key. However, the unit turns itself off auto-
ON
matically after 1 hour.
3.2. Adjusting the volume
Turn the left control knob
. The volume increases
or decreases.
G
Warning
Danger of Accidents – Health Warning
-
Excessive volume poses dangers and risks.
Adjust the volume to a level that will allow you
to still hear traffic noises (horns, sirens, etc.).
3.3. Activating the Tone Menu
Press
. This activates the tone menu.
The following parameters may be adjusted:
(Bass),
(Treble),
(Fader),
T r b
. a d
(linear setting)
(Subwoofer) and
. l t
S u b
(Loudness).
B a s s 0
.M
BasTrb .ad Bal .lt Sub Ldn
Settings for the bass, treble, fader, balance and loud-
ness are saved separately for wavebands AM, SW,
FM, for traffic reports, navigation messages, for tele-
phone, CD and CDC use.
Adjusting the bass
Press
followed by the multifunction key
B a s s 0
.M
BasTrb .ad Bal .lt Sub Ldn
Set the desired bass level using the right control
knob
.
Setting the treble
Press
followed by the multifunction key
B a s
T r e b l e 0
(Balance),
.M
B a l
L d n
BasTrb
.ad Bal .lt Sub Ldn
Set the desired treble level using the right control
knob
.
Fader
Press
followed by the multifunction key
. a d e r
.M
BasTrb .adBal .lt Sub Ldn
.
Bas
Use the right control knob
setting.
.
Trb
.
.ad
0
to set the desired fader
7
3. General Operation
Advertisement
Table of Contents
