Tone-Burst Frequency; Default Tone Value; Default Sq Value - Alinco DR-B185HT Instruction Manual

The options are between 173 and 136MHz in 1MHz step.
This value should be lower than the frequency set in the previous
chapter.
3.
Press the dial.
The unit will go back to menu mode.
„ „

Tone-Burst Frequency

This is to access Tone-Burst repeaters which require a certain pitch of
audible tone to activate "sleeping" repeaters. Usually, a repeater system
does not require the tone once the repeater is activated.
1.
Rotate the dial or press the [UP]/[DOWN] keys on the microphone
to display the menu number "16".
The current setting will appear on the
display.
The default setting is "1750" (1750Hz).
2. Press dial to display SET, then rotate dial or press the [UP]/[DOWN]
keys on the microphone to change the setting.
The options are as follows.
1750 (1750Hz), 2100 (2100Hz), 1000 (1000Hz), 1450 (1450Hz)
▼
3. Press the dial.
The unit will go back to menu mode.
PARAMETER SETTING MODE
„ „

DEFAULT TONE VALUE

Set the CTCSS tone encoding value displayed by operating the
after turning on the power.
1. Rotate the dial or press the [UP]/[DOWN] keys on the microphone
to display the menu number "17".
The current setting will appear on the
display.
The default setting is "OFF".
2.
Press dial to display SET, then rotate dial or press the [UP]/[DOWN]
keys on the microphone to change the setting.
Available parameters are OFF and 67.0Hz to 250.3Hz (See the
table in the next page). When a tone frequency is selected, it
resumes as a default parameter every time the unit is turned on,
regardless of previous setting. By setting OFF, the tone selected by
key remains unchanged.
TS/DCS
3. Press the dial.
The unit will go back to menu mode.
„ „

DEFAULT SQ VALUE

Set the CTCSS tone decoding value which is displayed by operating the
key after turning on the power.
TS/DCS
1. Rotate the dial or press the [UP]/[DOWN] keys on the microphone
to display the menu number "18".
The current setting will appear on the
display.
The default setting is "OFF".
7
key
TS/DCS
28