Tone Burst Frequency; Apo (Auto Power Off); Battery Save Function; Beep Sound - Alinco DJ-C7T Instruction Manual

(4) Tone Burst Frequency

1. "1750" is displayed on the LCD.
2. Rotate the dial to select the Tone Burst Frequency
setting as follows:
"1750" -> "2100" -> "1000" -> "1450"

(5) APO (Auto Power Off)

This function automatically turns the power OFF if there is no
key operation for a specified period of time to prevent wasting
the battery charge.
This is useful when you forget to turn off the transceiver.
1. " " is displayed on the LCD.
2. Rotate the dial to select a setting value as follows:
"OFF" -> "30"
Just before cutting the power OFF, a beep will be heard. Select
the time from 30, 60, 90 minutes, and OFF. When OFF is
selected, this function does not work.
To turn the power ON, press the POWER (PWR) key again.
Tip
With this function ON, even if the DJ-C7 receives signals, it
won't reset the turn-off period. Only key operations will
expand the period.
-> "60" -> "90"

(6) Battery Save function

This function prevents wasting battery power by switching the
reception circuit power supply OFF.
With this function ON, the transceiver will be in a hibernation
state if there is no key operation or received signals for a
continuous period of 5 seconds.
1. " " is displayed on the LCD.
2. Rotate the dial to switch ON/OFF the Battery Save
function.
When you set it to ON, the
• The factory-shipped default is set to ON.
• This function will be released temporarily when the DJ-C7
receives signals or there is a key operation.
• This function will not be performed while the DJ-C7 is under
scanning.
• LCD displays even when the Battery Save function is active.

(7) BEEP Sound

This function sounds a beep during operations. If you feel it is
noisy or annoying, you may turn off the sound.
1. " " is displayed on the LCD.
2. Rotate the dial to switch ON/OFF the BEEP Sound as
follows:
"oFF BEEP"
icon will appear on the LCD.
-> "on BEEP"
6
25