To Receive Signals; Monitoring Function; To Transmit Signals; Call Mode - Alinco DR-B185HT Instruction Manual

„ „

To Receive Signals

1. Turn on and adjust audio/squelch levels.
2.
Select your desired frequency.
When a signal is received at your
desired frequency,
and receiving sound will be heard. The
S-meter will swing according to the
receiving signal strength.
„ „

Monitoring Function

This function allows you to cancel the squelch operation so that weak
signals that are below the squelch level can be heard.
1.
Press and hold the
SQL
key.
will appear and the squelch
opens.
2. To cancel the monitoring function, press
[PTT] key or any key on the unit except
for the knob.
„ „

To Transmit Signals

1. Select your desired frequency.
2. Press the [PTT] key on the microphone.
The TX indicator lights red and starts
transmitting.
3. While pressing the [PTT] key, speak
into MIC in a normal voice.
Place the microphone about 5 cm away
from your mouth when you speak.
will light up
key for 1 second or press MIC"s
TX
TX
VOL
PWR
SET
FUNC
Release the [PTT] key to return to receiving mode.
Pressing the [PTT] and [DOWN] keys simultaneously will transmit a
tone call signal.
When the auto-dialer is set, pressing the [PTT] and [UP] keys
simultaneously will transmit the auto-dialer signal set in advance.
When the 2Tone is set, select a mode other than menu mode, then
while pressing the
and the transceiver will enter 2Tone mode. Press [PTT] to transmit
2Tone which is set in advance.
If the [PTT] key is pressed outside of the transmission frequency
range, [OFF] will appear on the display and warning beep sounds
until the [PTT] is released. Enter within the transmitting frequency
range to resume transmitting.
„ „

CALL mode

This is a memory mode that allows the transceiver to quickly recall the
assigned memory channel by simply pressing the
of the current status of the unit.
1.
Press
the display and the transceiver enters
the CALL mode. In this mode, the main
dial or the [UP]/[DOWN] keys cannot change the frequency or
memory channels.
2.
Press
CALL
3.
No scan functions are available in CALL mode.
To store a desired setting in the CALL channel, follow the memory
mode programming instructions and assign your selected settings
to memory channel C. The call channel can be modified but cannot
MW LOCK H/L
V/M TS/DCS CALL
be eliminated or hidden.
Basic Operations
key, press Dial. The
FUNC
key. The icon appears on
CALL
key again or press key to exit CALL mode.
V/M
5
icon will light up
16
key, regardless
CALL